Denali CANsmart™ Controller Gen II - BMW R1200 LC & R1250 Series

Denali CANsmart™ Controller Gen II - BMW R1200 LC & R1250 Series

• Fits the BMW R1200 LC & R1250 Series Gen 2
• Plug and play installation
• Dozens of customisable settings that can be controlled by CANsmart accessory manager software
• Simple circuit mode

Denali CANsmart™ Controller Gen II - BMW R1200 LC & R1250 Series

High/Low Sync
Set passing lamps and auxiliary lights to switch between a programmable high/low setting with the factory high beam switch.

ON/OFF and Dim
Independently control two sets of lights ON/OFF and change intensity level from your original vehicle switches.

Modulate Lights
Set auxiliary lights to modulate for increased visibility to other motorists.

Flash to Pass
Need to get someone's attention? Pulse your high beam switch three times and your auxiliary lights will strobe three times fast.

Cancel With Indicators
This feature cancels the corresponding auxiliary light when you turn your indicator on preventing powerful auxiliary lights from overpowering your signal.

Inverse Flashing With Hazards
This features flashes your auxiliary lights inversely to your hazard lights, increasing visibility during road side emergency's.

Plug & Play Horn Installation
Quickly and easily connect high power aftermarket horns like our SoundBomb™ without having to add an additional harness or relay.

Strobe with Horn
With this feature selected the CANsmart™ software will automatically strobe your passing lamps or auxiliary lights when you sound your horn. This feature works whether you have the factory horn or SoundBomb™ horn installed.

Deceleration Activated "Smart Brake" Technology
The CANsmart™ reads vehicle speed in real time to activate your auxiliary brake light during deceleration before you even touch the brake. You can adjust the sensitivity and minimum speed at which the Smart Brake Feature will activate.

Flash Pattern Braking
The CANsmart™ provides four different flash patterns that make our super bright auxiliary brake lights even noticeable to motorists behind you. You can set auxiliary brake lights to only flash under hard braking, flash continuously as your brake is applied or flash four times rapidly then hold steady (California legal flash rate).

Circuit Function Selector
The Circuit Function Selector in the CANsmart software will let you run any accessory of your choice on any of the four circuits. Click on a circuit icon to open the drop down menu and make your selection from the list of available circuit functions.

Switched Power Source
The CANsmart™ provides a universal "accessory" option which simply gives you clean switched 12V power. That means whatever accessory you connect to this circuit will turn on and off with your ignition.

Delay Time Out
You can also set the accessories on this circuit to have a delayed time out. This will keep them powered for up to 30 seconds after your turn off your bike.

On Board Power
The "accessory" circuit option is ideal for powering your GPS, phone, heated gear or any other electronic device.